Owner`s manual

General Maintenance
5.11
Brake Pad Inspection
The brake pads must be inspected when specified in the
maintenance schedule. See Maintenance Schedule
information on page
5-2. Visually inspect the brakes by
looking at the remaining brake pad material through the
sides of the brake caliper.
Replace the brake pads if
either pad’s thickness is
0.05 in (1.35 mm) or less. If
the brake pads (A) are
worn, replace both brake
pads immediately.
The brake rotor should
al
so be checked for
thickness. The minimum
thickness is 0.15 in (3.85
mm).
Suspension
Front
 For maintenance, see Maintenance Schedule on
page
5-2.
 To adjust the fork, see Suspension Adjustment on
page
4-16.
Rear
CAUTION: The shock absorber
assembly contains highly
pressurized gas.
 Do not attempt to tamper with or open the cylinder or
shock.
 Do not subject the shock to high temperature or open
fl
ame.
Doing either of these can cause the cylinder or shock
to explod
e causing personal injury or death.
For maintenance, see Maintenance Schedule on page 5-2.
To adjust the fork, see Suspension Adjustment on
page 4-16.