Owner`s manual

General Maintenance

5.10

Front Brake

Inspect the level of the front

brake fluid through the sight

glass (C). If the fluid level is

visibly below the low level

indicator (B), brake fluid must

be added. Clean any dirt or

debris from the cover (A)

before opening the reservoir.

Note: The motorcycle should

be i

n an upright position prior

to checking fluid level.

1. Remove the two Phillips screws securing the cover

onto the reservoir.

2. Add new DOT 4 brake fluid.

3. Inspect the cover seal, ensuring that it is free of any

or damage and that it is positioned correctly.

4. Install the cover and tighten the Phillips screws.

Rear Brake

Inspect the level of the rear brake fluid by inspecting the

level through the reservoir housing. The reservoir housing

is located inboard on the frame behind the heel guard. If

the fluid level is visibly below the low minimum “MIN”

indicator (C), brake fluid must be added until level reaches

the upper “MAX” indicator (B). Do not overfill.

Note: The motorcycle should be in an upr

ight position prior

to checking fluid level.

Clean any dirt or debris from the cap and reservoir opening

(A) befo

re opening the reservoir. Unscrew the cap and add

new DOT 4 brake fluid. Inspect the cap seal ensuring that

it is free of any wear or damage then reinstall the cap.