Owner`s manual

General Operation
4.13
Quick Charger LED Indicators
A. Ammeter
The Ammeter LED is an amber indicator that indicates
the amount
of current output and should gradually
ramp down from “IIIIII” to “I”.
B. 80% Charge
T
he 80% Charge LED is an amber indicator. If it is on
soli
d, the bulk charge phase is complete, 80%
charged. Charger is now in absorption phase. If the
indicator is flashing, there are two issues that can
cause this to occur:
 Th
e charger and BMS are balancing.
 The BMS is cutting off the charge because one or
more cells have reached maximum voltage.
C. 100% Charge
Th
e 100% Charge LED is a green indicator. If it is on
solid, the charg
ing is complete and the off-board
accessory charger will enter maintenance mode. If it is
flashing, the absorption phase is complete and the
charger is in finish phase.
D. AC ON
The AC ON LED is an amber indicator. If it is on solid,
th
e AC
power is good. If it is flashing, the AC voltage
is low. Check for proper voltage, and if an extension
cord is being used, verify that it is the correct length.
Maximum length is 25 ft. (7.6 m) 12 AWG.
E. Fa
ult
The Fault LED is a red indicator which indicates there
is a charger error. If it is flashing, reset the charger
and see
“Troubleshooting”, on page 6-1.