Owner`s manual

General Operation
4.12
To charge using the Quick Charger:
1. Ensure that the key switch is in the OFF position.
2. Locate the auxiliary charging connector and remove the
protective cover.
3. Connect the power pack charger to the power pack
connector (A).
4. Always connect the charger to a GROUNDED outlet.
When using an extension cord, avoid excessive voltage
drops by using a grounded, 3-wire, 12-AWG cord no
longer than 25 ft (7.6 m). The charger can be used on
120 V AC or 240 V AC current. The voltage does not
change the amount of time that the motorcycle takes to
charge.
5. Connect the integrated charger. See Charging the
Powe
r Pack Single Charger (integrated) on
“Charging
the Power Pack”, on page 4-10.
6. When the power pack is fully charged, disconnect the
cha
rgers and reinstall the protective cover.