Operation Manual

General Maintenance
5.11
Rear Brake
The reservoir housing is located inboard on the frame
behind the heel guard.
Note: The motorcycle should be in an upright position prior
to checking fluid level.
Inspect the level of the rear brake fluid through the
reservoir housing. If the fluid level is visibly below the low
minimum “MIN” indicator (C), brake fluid must be added
until level reaches the upper “MAX” indicator (B). Do not
overfill. Clean any dirt or debris from the cap and reservoir
opening (A) before opening the reservoir.
Unscrew the cap and add new DOT 4 brake fluid. Inspect
the cap seal ensuring that it is free of any wear or damage
then reinstall the cap.