Operation Manual

General Operation

4.11

To charge using the Quick Charger

1. Ensure that the key switch is in the OFF position.

2. Locate the accessory charging connector (above the

motor) and remove the protective cover.

3. Connect the power pack charger to the power pack

connecto

4. Always connect the charger to a GROUNDED outlet.

When using an extension cord, avoid excessive voltage

drops by using a grounded, 3-wire, 12-AWG cord no

longer than 7.6 m (25 ft). The charger can be used on

120 V AC or 240 V AC current. The voltage does not

change the amount of time that the motorcycle takes to

charge.

5. Connect the off board accessory charger. See

“Quick

Charging (Off Board Accessory Charger)”, on

page 4.10.

6. When the power pack is fully charged, disconnect the

charger(s) and rein

stall the protective cover.