Operation Manual

Troubleshooting
6.5
General Troubleshooting
SYMPTOM POTENTIAL CAUSE POTENTIAL SOLUTION
Motorcycle does not turn on Power Pack not charged. Key not properly engaged.
Motor sto
p switch turned OFF. Fault code set.
Charge Power Pack. Recheck key in ignition, turn OFF/ON
again. Press the motor stop Switch ON button. See Charge
Fault Code chart on page
6.7 or see Understanding BMS
Flash Code Patterns starting on page
6.7.
Charger not working A/C power missing fault code set Check A/C outlet for power, A/C source check fuse/voltage.
See Charge F
ault Code chart on page
6.8 or see
Understanding BMS Flash Code Patterns on page
6.8.
Handlebars wobbly (shimmy) Incorrect tire pressure Inflate to correct tire pressure. See page
5.13.
Deformed front tire Replace/balance front tire with the same tire supplied from the
fact
ory.
Bald tire (excess wear) Replace/balance tire with the same tire supplied from the
fact
ory.
Loose headset bearings Inspect the headset for wear or damage, replace any worn or
damaged p
arts. Tighten the headset pre-load.