Operating instructions

Page 19

FRAMING CONSTRUCTION CORNER LOCATION

WARNING: Install the hearth protector or finished hearth extension only as specified. The exten-

sion must extend a minimum of 16" in front of the stove door opening and must be 47 1/2" wide mini-

mum. Refer to page 6 for calculation of R and K values. (See Page 19).

NOTE: No floor protector or finished hearth is needed directly under the Model 80ZC Cabinet, only the

hearth protector is needed.

CONTINUED FRAMING AND INSTALLATION

41 1/2"

47 1/2"

CHIMNEY CAP

STROM COLLAR

ROOF FLASHING

2" X 4" STUDDING

CHIMNEY PIPE

METAL FIRE STOP

USE FIRE CODE SHEET ROCK

2" X 4" STUDDING

A SINGLE HEADER MUST BE INSTALLED ABOVE CABI-

NET. VERTICAL 2" X 4"‘s MUST BE TURNED FLAT.

NOTE: FINISHED WALL MUST BE 2 1/2" IN FRONT OF FACE

OF ZC CABINET (WITHOUT HOOD TRIM ATTACHED).

NOTE: A DOUBLE HEADER MUST BE USED ON A LOAD

BEARING WALL.

3. The 80ZC cabinet exterior roof or chase framing as follows:

FIGURE 19