Operating instructions

Page 10
CONTINUE FRAMING AND INSTALLING
INSTALLING INSULATION TO 80ZC
1. Take (1) one piece insulation 8" X 11 1/2" place in middle front.
2. Take (2) two pieces insulation 8" X 10 1/2" place on each side of 8" X 11 1/2". (SEE FIGURE 8)
3. Now place (2) two pieces 8" X 48" over the (3) three pieces just installed. (SEE FIGURE 9)
3. Take the insulation cap and place rear lip of insulation cap under front of pipe starter. Using (4)
four screws provided fasten insulation to top of cabinet. (SEE FIGURE 10)
FIGURE 9
INSULATION - (2) TWO PIECES
ON TOP OF OTHER INSULATION
8" X 48"
FIGURE 8
INSULATION - (3) THREE PIECES
SIDE BY SIDE
8" X 11 1/2"
8" X 10" 8" X 10"
TOP VIEW
FIGURE 10
INSULATION CAP
(2) TWO
SCREWS
(2) TWO
SCREWS
TOP VIEW
PIPE STARTER
SIDE VIEW
INSULATION
REAR LIP