User's Manual

V0.2.32 Draft version, for evaluation sample only.

Hardware Installation

To install the print servers, you need to complete these steps:

ԦConfirm that your printer USB port work well.

ԦConnect the print server to the network and printer and plug in the print server.

ԦCreate a configuration page from the print server.

Follow these instructions to install the print servers, please refer to any peripheral

you are connecting to the print server:

1. To ensure your printer work well, do one of the following:

ԦSend data through the parallel (USB) port of each printer you are connecting to the

print server, or generate a printer self-test page.

2. Turn off the power for each printer.

3. Connect the print server to printer.

4. Plug the AC power adapter into the power receptacle in the side of the print server.

5. Plug the AC power module into the wall out-let, the print server is switched on after you

plug it in.

6. Check the LED’s marked as status. It should be flash five times normally, if not, please

contact your local dealer for repair or replacement.

7. Turn on the power of your printer to begin printing.