User Manual

Broadband DSL/Cable Wireless Router User’s Manual

Preparation

The Broadband DSL/Cable Wireless Router comes with a

pre-set default IP address, 192.168.1.1. It also features a

DHCP server. To configure it over your TCP/IP network,

please follow the directions listed below.

Note: If you’re installing the Broadband DSL/Cable Wireless

Router in a pre-existing IP network, please see the

Configuring Broadband DSL/Cable Wireless

Router in Pre-Existing IP Networks section later in

this chapter.

1. Please ensure your computer (Windows 95/98/Me or

Windows NT/2000) has TCP/IP protocol installed. If

not, please install the protocol first and then proceed

to Step 2.

2. In your Network Properties dialog box, select the

Obtain IP address automatically option. When

done, restart the computer.

3. After the computer restarts, open your browser.

4. Type the default IP address (192.168.1.1) in the

Location box and press Enter. The device’s

Home Page will then appear.

5. It then displays an authentication dialog for the

Broadband DSL/Cable Wireless Router. Type the