User Manual

Troubleshooting
9 - 12
You have to do the same "arp" command to specify an
entry on the NT/UNIX computer as a gateway in order
for it to forward your subsequent "ping" or/and "tftp"
commands to the print server.
b. If the gateway computer is a Novell NetWare file server:
1. Due to the presence of this NetWare file server, the
IPX/SPX protocol might be used on your network.
Therefore, we strongly suggest you run the
PSAdmin from any client computer and select
"Manual Setup" to specify the print server's IP
address (For more detailed information about
Manual Setup, please refer to Chapter 3).
2. If the solution described above is not applicable, you
have to follow the instructions below to set up the
print server's IP address.
For the purpose of explanation, we assume the NT server is
on Segment A and its IP address is 192.72.214.66 (subnet
mask: 255.255.255.224), the print server is going to be
installed on Segment B, with IP address, for example,
192.72.214.100.
1. Find an unused IP address on Segment A for temporary
use in the following steps, for example, 192.72.214.68.
2. Connect your print server to Segment A as a networked
node.