SDS

Page 5 of 10
Safety Data Sheet
acc. to OSHA HCS (29 CFR 1910.1200)
Printing date 06/26/2015 Reviewed on 06/26/2015
Trade name: General Formula
(Contd. of page 4)
41.0
·
Control parameters
·
Components with limit values that require monitoring at the workplace:
75-65-0 2-methylpropan-2-ol
PEL (USA) Long-term value: 300 mg/m³, 100 ppm
REL (USA) Short-term value: 450 mg/m³, 150 ppm
Long-term value: 300 mg/m³, 100 ppm
TLV (USA) Long-term value: 303 mg/m³, 100 ppm
EL (Canada) Long-term value: 100 ppm
EV (Canada) Short-term value: 150 ppm
Long-term value: 100 ppm
LMPE (Mexico) Long-term value: 100 ppm
A4
·
Additional information:
No further relevant information available.
·
Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures for handling chemicals should be followed.
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
·
Engineering controls:
Provide adequate ventilation.
·
Breathing equipment:
Suitable respiratory protective device recommended.
Use suitable respiratory protective device when aerosol or mist is formed.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has therefore to be
checked prior to the application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to
be observed.
·
For the permanent contact gloves made of the following materials are suitable:
Nitrile rubber, NBR
Neoprene gloves
Butyl rubber, BR
·
Eye protection:
Safety glasses
(Contd. on page 6)