User manual

Version ZerioPlusI&OM_V1.01
EDA-Z5008 & Z5020 - Installation and Operation Manual
Electro-Detectors Page 8
3.5 Alarm Conditions
In a fire condition, a screen similar to that below will be displayed. The Fire LEDs will flash and the appropriate zone LED(s) will flash
and the system sounders will be activated (assuming the system is programmed to do this). The first two lines on the display details the
first zone that has been activated, the last zone to activate, and the total number of zones in alarm. The third line details the event number,
device type and its number. If the device location has been programmed on the panel, the last line details the text location of the device in
alarm. If this description is longer than 20 characters it will scroll across the screen. If more than 1 alarm occurs, the bottom two lines will
scroll across the screen
ZN: FIRST LAST TOTAL
001 001 001
001 CALLPOINT 006
First Floor Next to W
3.6 Silence the Alarm.
When it is certain that it is safe to return to the building the ‘Silence Alarms’ button should be pressed. The user will then be prompted to
enter a valid user password. Up to 30 seconds should be allowed for all sounders to silence with a radio system. If the device is still in an
alarm condition the sounders will not sound again unless another device goes into alarm. The sounders will automatically silence after 60
minutes.
3.7 Re-Sound the Sounders
There may be times when the sounders have been mistakenly silenced - for example if the alarm was genuine but someone mistakenly
pressed silence. To re-sound the alarm, press the ‘Sound Alarm’ button.
3.8 Reset the Alarm
Assuming the reason for the alarm condition has been investigated, pressing ‘Reset’ after silencing the alarm will return the system to its
normal operation screen. Again, the user will need to enter a valid password. The screen will display any faults that were detailed prior to
the alarm condition or any new fault that occurred during the alarm condition. If the device has remained in alarm (i.e. the glass has not
been replaced in a callpoint or a smoke detector still thinks smoke is inside the unit) after silencing the alarm and then pressing RESET,
the panel will re-display the alarm and sounders will sounder again.
3.9 Menu Navigation
To enter the menu system, press ‘MENU’ and enter a valid password. ‘Main Menu’ will appear. The options available on the main menu
(and sub-menus) will be depend on the password entered, which is determined by the access level.
To scroll through the menu the ‘↑’ or ‘↓’ keys should be pressed. In order to select a menu option the ‘→’ key should be pressed. To
return to the previous menu screen from a sub-menu the ‘←’ should be pressed. Pressing ‘Cancel’ will return to the system screen where
any faults or alarms will be displayed if present.
If a non-menu screen is selected the ‘Cancel’ button should be pressed to return to the menu also without making any changes.
Subsequently, then pressing ‘Cancel’ will return to system normal screen.
If any changes are made to settings, these are generally saved using the ‘Enter’ key as detailed on the display. If an alarm occurs while in
menu mode, the menu will be automatically cancelled, and the alarm message displayed. If a fault occurs while in the menu mode, the
fault LED will light, but the display will remain in the menu mode until cancelled in the usual way.
If the screen is left unattended for a period of time (default 5 minutes) the screen will automatically return to the normal screen.
Main Menu
1→Setup
2 Disable/Enable
3 View Events