User manual

Version ZerioPlusI&OM_V1.01

EDA-Z5008 & Z5020 - Installation and Operation Manual

Electro-Detectors Page 7

3. User Operation

3.1 System Normal

In normal operation the screen will show either the date and time, or the supplier/service contact details. If requested by the customer, the

unit will be configured to alternate between the two. Also a single green “Supply” LED will be illuminated.

Thursday

A.N.Other Fire 25-05-2011

01234 5678901

11:02:31

3.2 Fault Conditions

If a fault occurs, a message will be displayed and the internal buzzer will sound. The top line of the message will alternate between the

supplier/service contact name, and their telephone number. The second line details the current fault number, the device type, and the

device number. The third line details the fault type. Finally, on the bottom line, the device location is displayed (if programmed). The

description has a maximum length of 59 characters and will scroll across the screen if more than 20 characters. Appropriate action

should be taken to remedy the fault as this may affect the operation of the fire alarm system. If in doubt, the system maintenance

company should be contacted.

A.N.Other Fire 06677 663425

001 SMOKE/SOUND 005 001 SMOKE/SOUND 005

UNIT REMOVAL UNIT REMOVAL

Floor Garden Entr 1

Floor Garden Entr

If more than one fault exist on the system they will scroll round every 5 seconds. Pressing the ‘↑’ or ‘↓’ cursor key will automatically

move to the previous or next fault.

3.3 Silence Buzzer

If the panel buzzer is sounding following a fault, it can be silenced with the ‘Silence Buzzer’ key.

Once the ‘Silence buzzer’ button has been pressed the panel assumes that the fault has been acknowledged and does not re-sound the

buzzer, unless a new fault occurs. The indicator on the device will continue to flash until the fault is reset – see below.

3.4 Reset a Fault

A fault will be displayed on the panel until the system is reset, even if the fault condition has been rectified. Assuming the fault has been

rectified, pressing reset on the panel will reset the panel and the devices on which a fault has occurred. The system normal screen will

then be displayed. If the fault is still present or re-occurs it will be re-displayed. Where there are multiple faults, all will be reset at the

same time. It is not necessary to silence a fault before resetting it. The particular device or devices in fault will also flash a green LED and

beep.

For a list of faults, their most common causes and ways to rectify faults see Appendix 7.

Please note: No operator serviceable parts are contained within this panel. Always refer to a qualified technician

for parts and servicing.