User manual

Version ZerioPlusI&OM_V1.01
EDA-Z5008 & Z5020 - Installation and Operation Manual
Electro-Detectors Page 6
2. Front Panel Display and Keys
Figure 1.1 Front Panel Display and Buttons
Menu Function Cancel Enter
Sound Silence Silence Reset
Alarm Alarm Buzzer
1 2 3 4
EN54-2/4/25
Made in UK
STATUS
FAULTS
FIRE
Supply
Delays Active
Disablements
Tes t Mo de
Remote Signal
Common
System
Tx/Rx
Remote Signal
Device Battery
Zones In Alarm
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
EDA-Z5020
Faults
Common – Device or panel has a
fault – see the main display for
details.
System – System failure.
Tx/Rx – Not implemented.
Remote Signal – Not implemented.
Device Battery – Not implemented.
Status
Supply – This LED will be
illuminated when mains is present
Delays Active – Illuminated if a fire
condition exists and delays are
programmed.
Disablements-Illuminated if any
devices or zones are isolated.
Test Mode-Illuminated if any test
modes are operational. The buzzer will
pulse and can be silenced by pressing
‘Silence Buzzer’
Remote Signal-Not implemented.
Keys
Menu – Press to initiate the menu system.
If held down for longer than 2 seconds, the
LED’s will follow a test sequence (lamp
test).
Function 1 – Programmable for use as
Evacuate and Alert functions. The default is
to do nothing. By use of special software
these function keys can be programmed
perform specialist functions
Cancel - Used to return to the main screen
from a menu or to return to the menu from a
programming screen.
Enter - This is used to accept information
programmed into the panel.
Sound Alarm – To sound the alarms this
button should be pressed. Following an
alarm condition that has since been
silenced, pressing this button will re-sound
the alarms
Silence Alarm - If the panel is in a fire
condition this will silence the sounders.
Silence Buzzer- Silences the panel buzzer
for all currently displayed faults (fault
acknowledgement).
Reset – Resets the panel from an alarm or
fault condition. Note that the system must
be silenced before it can be reset from a fire
condition.
Navigation Keys
Used to navigate through the menu
structure and programming / status
screens.
In a multiple fault or alarm condition,
the up and down arrow keys allow
the user to scroll through all the
current events. The display will also
scroll automatically every 4 seconds.