Instruction manual

INSTRUCTION MANUAL - Issue 1 - 07/2014 | 25
CHANNEL SAFETY SYSTEMS t: 0845 884 7000 | w: www.channelsafety.co.uk
6.22 - Add Antenna – commissioning users
1.Main Menu>>1.Setup>>4.System Setup>>5.Add Hardware>>1.Add
Antenna
Power down the panel before connecting the wired antenna. Once
powered up, check that the supply light is illuminated on the antenna and
that the status light is  ashing. Navigate to the add antenna menu and
press . Select the wired antenna (E00001), press and press Enter.
Once added, signal information from the antenna will be displayed on
screen. Press Cancel to return to the menu. Do not assign a wired
antenna as Antenna 01, as this slot is reserved for the panel antenna
(EDA001).
Once completed power down the panel and power it up again to ensure
both antennas are synchronised. Clear the verify table for all devices, then
leave the system for approximately 15 minutes to allow the verify table to
regenerate. In the device assignment menu select ‘1-Auto Assign’. This will
assign the devices to the antenna they receive the strongest signal from.
This process will take 20 seconds per device.
6.23 - Adding a Repeater (Booster) Panel – commissioning users
1.Main Menu>>1.Setup>>4.System Setup>>5.Add Hardware>>2.Add Rpt
Panel
Repeater panels should be added one at a time. Ensure all panels are in
their surveyed positions, the control panel is powered up and the repeater
panels are powered down. Select the next available panel number (the
main panel is always panel 01). When prompted, the memory card from
the repeater panel will need to be placed into the memory card slot of the
main panel. Do not mix the memory cards up. The panel will then copy
the system settings on to the memory card. After following the prompts
and re tting the correct card into each panel, the repeater panel can be
powered up. A count will be displayed showing the signal strength of the
panel. Press cancel to leave this screen at any time. Clear the verify table
for all devices and wait approximately 15 minutes for the verify table to
rebuild. Run auto con gure (see 6.27 – Auto Con gure), then assign
devices; see 6.20 – Device Assignment.
6.24 – Add Pager – commissioning users
1.Main Menu>>1.Setup>>4.System Setup>>5.Add Hardware>>3.Add Pager
Power down the panel before connecting the pager unit. Follow the on-screen prompts.
6.25 - Remove Hardware – commissioning users
1.Main Menu>>1.Setup>>4.System Setup>>6.Remove Hardware
Use this menu to remove antennas, repeater panels and pagers from the system. Once the panel indicates that the
hardware has been removed, it can be powered down and disconnected.
Once an antenna or repeater panel has been removed, the verify table should be cleared and allowed 15 minutes
to regenerate, then devices should be reassigned using the auto assign function. This will ensure the system
operates correctly.