Instruction manual

INSTRUCTION MANUAL - Issue 1 - 07/2014 | 18
CHANNEL SAFETY SYSTEMS t: 0845 884 7000 | w: www.channelsafety.co.uk
6.6 - Set up a New System (Standard) – commissioning users
1.Main Menu>>1.Setup>>4.System Setup>>2.New Setup>>1.Standard
System
Devices are programmed via a radio link to the control panel. If the
system is known to have been used before then all the devices that are
logged on to the system must be removed  rst. To add or remove de-
vices on a system that is already set up; see 6.29 – Add Device and 6.30
– Remove Device.
Press Enter to start. You will be asked if you would like to put the system
into test mode (see 8.0 – Test Mode). Select YES or NO and press Enter.
The control panel will now check the airwaves for any radio interference
and select a suitable channel for the system. Press Enter to continue.
Select the antenna type. At the Device Programming screen, the device
needs to be put into programming mode. First remove the device from
its base.
1. If a smoke detector, heat detector or combined sounder detector
is being programmed; hold both the reset button and the unit removal
button down while you place the jumper link to the ON position.
2. If a sounder, beacon, callpoint, transmitter or I/O unit is being
programmed; hold down the unit removal button while holding a mag-
net over the reed switch and place the jumper link to the ON position.
Some newer devices are equipped with a log on button and do not
require the magnet to log on; simply hold down the button while the
jumper link is moved to the ON position.
Continue to hold the button(s) for approximately 5 seconds until a con-
 rmation of 3 beeps from the device is heard. The LED on the device will
now  ash green. The device is now in its programming mode. Press Enter
on the panel to search for the device and follow the prompts to set the
device options. When complete press Enter to program the device.
Once the device has restarted you will be asked to enter location text;
see 6.33 – Device Text. Text can be added at any time. Devices can be
added at any time in the Device Setup menu.
If the system has booster panels or additional antennas  tted, an auto assignment for all devices should be
performed once all devices have been added. See 6.20 – Device Assignment.