Operation Manual

12
10. TROUBLESHOOTING
ISSUES POSSIBLE CAUSES SOLUTIONS
Vacuum will not operate.
Batteries are discharged. Charge vacuum on Charger Base.
Dead battery (won’t hold
charge).
Replace battery (call your Zepter
Service Centre for info).
Contacts between Vacuum and
Charging Base are dirty.
Clean contacts off with damp
cloth. Be sure to dry contacts
completely before use.
No power coming through
electrical outlet.
Check fuse or breaker box -
replace fuse or reset breaker.
Electrical Turbo Brush will not
operate.
The two metal pins on Electrical
Turbo Brush are not in contact
with Vacuum.
Firmly insert the Electrical
Turbo Brush into the Air Intake
Nozzle of Hand Vacuum - this
will connect the Electrical Turbo
Brush Roller to the unit’s power
supply.
Electrical Turbo Brush is
clogged.
Remove hair, threads, etc.
from Electrical Turbo Brush
(see chapter 6).
Vacuum will not pick up, or
suction power is weak.
Dust Cup container is full. Empty Dust Cup.
Dust Cup Filter needs cleaning
or replacement.
Remove Dust Cup Filter and
check for blockage in air flow
duct and remove debris. Replace
Dust Cup Filter if necessary (call
your Zepter Service Centre for
info).
Unit needs to be recharged. Charge unit on Charger Base.
Dust escaping from Vacuum.
Dust Cup container is full. Empty Dust Cup container.
Dust Cup Filter not installed
properly.
Review Dust Cup Filter
installation instructions and
re-insert Filter.
Puncture/hole in Dust Cup Filter.
Replace Dust Cup Filter (call your
Zepter Service Centre for info).