Operation Manual

8
➡
➥
➥
6. MAINTENANCE
Emptying/cleaning
Careful cleaning of the dust container and filters.
1 Remove the whole dust container by pressing the release button and twisting
the dust container off.
2 Pulling out the filter unit (4) and emptying the contents of the dust container into
a suitable vessel or bag.
(The filter can be shaken clean or cleaned and rinsed using warm water. Make
sure that the parts are dry before they are reassembled).
3 Reassemble the components.
Firstly assemble the filter baffle (4.2) onto the washable filter (4.1), then put the
filter into the filter unit (4), refer to below pictures.
Secondly assemble the dust container by following the detaching procedure in
reverse.
The Filtration System Set PWC-400-102 is available individually should it need
to be replaced. Contact your local Zepter Service Centre.