Operation Manual

1 2

The appliance does not need any particular maintenance, but it is advisable to go

through the operations described below in order to ensure perfect efficiency.

After periods of intense use (check at least once every three months) it is

necessary to check the efficiency of all filtering elements.

The appliance outer surfaces can be cleaned with a cloth soaked in neutral

detergent. Should the appliance fall or overturn, switch off immediately and

disconnect from the mains.

If the machine gets in contact with water, dry it with a dry cloth and wait a few

minutes before switching on again.

Do not put away the appliance whilst the tank still contains dirty water, as this

may cause bad smells from mould and encrustations forming inside the tank.

IMPORTANT! Before carrying out any type of maintenance, turn the

machine off and disconnect from the mains.

9.1 FILTERS

The following filters should be replaced immediately if you notice any

damage to them! Contact your Zepter Service Centre for new filters.

FLOATER FILTER

This filter traps the bigger dirt (e.g. leaves) which are not kept by the rainstorm

of the Spray System

and is therefore an important gate-keeper and protector

for the next filter, the Air Intake Filter.

Check the efficiency of filter.

To do this, remove the filter with the help of the float, by pushing it up against

the filter. Wash the filter element with plenty of cold water and neutral

detergent. Do not leave the filter to dry on heaters or radiators! Allow the filter

to dry naturally (not on radiators or heaters). Do not use the appliance until the

filter is perfectly dry. Use of a damp filter could damage the appliance.

As soon as stains or mould appear on the filters surface, replace them with

new ones, to be found at a Zepter Service Centre. The life of this particular

component is strongly influenced by how much the appliance is actually

being used.

AIR INTAKE FILTER

This prevents particles that have not been fully filtered by the water from

reaching the motor. Check the efficiency of filters when you are cleaning

the purification tank. To do this, remove and rinse repeatedly the two filters,

separating them from the cover and the machine body (Pict.3) with the help of

a small pliers (eyebrow tweezers will do). Wash the filter element with plenty

of cold water and neutral detergent.

Do not leave the sponge filter to dry on heaters or radiators! As soon as stains

or mould appear on the filters surface, replace them with new ones, to be

found at a Zepter Service Centre. The life of this particular component is

strongly influenced by how much the appliance is actually being used.

9 - MAINTENANCE