Installation guide

FEATURES & CONTROLS

CONTROLS: FILTER CHANGE INDICATOR (Carbon Filters)

Filter Change Reminder (Carbon, if fitted):

When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with

a set of Carbon Filters to purify exhaust and fumes from cooking, and re-circulates the air

within the home. These Carbon Filters are required to be replaced after every 120 hours

of use. The Filter Change Reminder function in the microprocessor needs to be

switched on. The microprocessor in the controls when set, will elapsed and count

usage time and indicate by a flashing when carbon filter replacement is needed

every 120 hrs.

Setting the Filter Change Reminder:

When Off, hold for approx. 5 seconds.

The display will change from

(exhaust mode) to , (purifying mode/

carbon filters used) this indicates that the

elapse timer function is switched on and

Carbon Filters are used.

Filter Replace Indicator:

When the display starts flashing, the

Carbon Filters requires replacement after

120 hours of use.

Re-setting Function:

Once filters are replaced, with hood off,

press and hold , the display will appear;

hold for approximately 5 seconds until

on display disappears . The Filter

Change Reminder is now re-set and a new

120 hours elapse cycle is initiated.

hold 5 secs.

display from <--> to <C>

display from <C> to < >

display <C> flashes

Set Mode

Change Filters

To Reset