Installation Guide

11
Installation – Installing the Hood
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
3UHSDUHHOHFWULFDOZLULQJDQGGXFWLQJLQFDELQHW/RFDWLRQRIMXQFWLRQER[DQGEORZHURXWOHWFDQEHIRXQGRQSDJH
Fig.3
2SHQFDELQHWGRRUV/LIWUDQJHKRRGDQGVOLGHLWWKURXJK
the opening located in the bottom of the cabinet, Fig.3.
Make sure opening matches the dimensions on page 9,
Fig.1.
7KHUHDUHVSULQJFOLSVORFDWHGRQWKHOHIWDQGULJKWVLGHV
of the hood body which will temporarily hold the hood in
place, Fig.4.
Fig.4
Fig.5
6HFXUHXSSHUEUDFNHWVWROHIWDQGULJKWVLGHVRIKRRG
ERG\E\XVLQJ[´VFUHZVIRUHDFKEUDFNHW
)LJ0DNHVXUHWKHFDSWLYHQXWVFUHZKROHVRQ
the bracket are facing downward. Note: Due to limited
workspace in 30” cabinets you will need to use a right
angle or 2” long Philips head screwdriver.
3ODFHORZHULQVWDOODWLRQEUDFNHWVXQGHUXSSHULQVWDOODWLRQ
brackets located on left and right sides of hood body,
Fig.6. Note: The wider portion of the lower installation
bracket should be at the bottom.
Fig.6
1
2