Instructions

Filling without removing the tank
– raise the water tank cover
– Fill the tank with cold fresh water (the
maximum temperature of the water is 35℃)
– the maximum capacity is 0.6 litre
– low down the tank cover
Before using for the first time or after long pauses (e.g. holidays) the machine must be flushed out. This short procedure can flush out and cleans the
internal piping thoroughly.
There are two ways to fill the water tank: directly into the machine, by using for example a jug, or by removing the water
Filling by removing the water tank
–Hold the water grip at tilting angle as shown in
direction to remove the water tank from the
machine.
Fill the tank up to Fill the tank up to the “MAX”
mark with cold fresh water (the maximum
capacity is 0.6 litre).
–Slide the water tank slowly on water tank base,
when the water tank outlet is inserted in the
inlet receptacle, pushing firmly on the water grip
as shown in direction to lock the water tank .
Press the switch button
The lights at buttons become steady
when the machine is heated up
heating up time is 45 seconds
Press the lungo coffee button, wait for the appliance to
complete the flush out.
– Before pressing the button, make sure that:
– the handle is closed without capsule inside.
– the water tank is full.
– the water tank is firmly in place, otherwise water may
leak
– a large bowl ( 250ml size or above) is placed under
the dispenser.
press the lungo coffee button to start flush out.
– Open the handle when the flush out process
stopped automatically.
– Empty the cup.
– flush out cycle is finished.