Hood User Manual

www.zephyronline.com

Installation – Mounting the Hood

Top Duct Covers

Top Support Frame

Bottom Duct Covers

Bottom Support Frame

5. Remove tape securing electronics mounting bracket to hood and reposition electronics mounting bracket.

),*(,QVWDOOHOHFWULFDODQGGXFWZRUN$FDEOHORFNQRWVXSSOLHGPLJKWEHUHTXLUHGE\ORFDOFRGHV),*

(6HDOGXFWZRUNZLWKDOXPLQXPGXFWWDSH

6. Power up hood, verify all functions and check for leaks around duct tape.

 $VVHPEOH7RS'XFW&RYHUVZLWKORXYHUKROHVWRJHWKHURYHU7RS6XSSRUW)UDPHVHFXUH7RS'XFW&RYHUV

together by magnetic strips. Note: If using hood in ductless recirculating mode you must install the air

diverter plate to the Top Support Frame prior to assembling the duct covers. Turn to page 11 for more

details.

 6HFXUH7RS'XFW&RYHUVWR7RS6XSSRUW)UDPHE\XVLQJ[VFUHZVVFUHZVIRUHDFK7RS'XFW

&RYHU),*'

9. Assemble Bottom Duct Covers together over Top Duct Covers and secure together by magnetic strips.

Bottom Duct Covers should rest on top of the Hood Body.

FIG. D

Cable Lock

$ FDEOH ORFNLQJ FRQQHFWRU QRW

VXSSOLHG PLJKW EH UHTXLUHG

by local codes. Check with

local requirements and codes,

purchase and install appropriate

connector if necessary.

FIG. E

WARNING: Electrical wiring must be done by a qualified person(s) in

accordance with all applicable codes and standards. This range hood must be

properly

grounded. Turn off electrical power at service entrance before wiring.

FIG. F