User Manual and Installation

9
1. Measure from range top to desired hood bottom and
PDUNOLQH$´PLQLPXPIURPUDQJHWRS
2. Plum and mark center line.
 0DUNKRRGKHLJKWOLQH%´IURPOLQH$
 0DUNPRXQWLQJVSUHDGIURP&/´RQOLQH%
 )DVWHQ0[´VFUHZVLQWRVWXGVRQOLQH%EXW
do not tighten all the way. Note: Wood blocking may
need to be added behind the drywall if no studs are
present. Wall anchors may also be used but check
local codes for compliance. Failure to use suitable
wall anchors and screws to hold the weight of the
hood could result in personal injury or damage to
cooking surface or counter.
 5HPRYHWKHDOXPLQXPPHVK¿OWHUV
7. Hang hood onto the mounting screws and hand tighten
HDFKVFUHZ)LJ$6HFXUHDWKLUG0[´VFUHZ
WKURXJKLQVLGHRIKRRGLQWRZDOOIRUH[WUDVXSSRUW)LJ
$
8. Center and attach duct cover mounting bracket to wall
MXVWEHORZWKHFHLOLQJRUVRI¿WXVLQJ0[´VFUHZV
9. Install electrical and duct work. Seal duct work with
aluminum duct tape.
10. Power up hood and check for leaks around duct tape.
11. Place telescopic duct covers onto hood and extend
LQQHUWRSGXFWFRYHUXSZDUGVDQGVHFXUHWRGXFWFRYHU
EUDFNHWXVLQJ0[VFUHZV5HLQVWDOOPHVK¿OWHUV
* If using hood in recirculating mode you must secure the
air diverter plate onto wall before installing duct work
and duct covers. You will also need to install charcoal
¿OWHUVDQGEUDFNHWV7XUQWRSDJHIRUPRUHGHWDLOV
18-
7/16
”
Brackets are
pre-installed
Fig. A1
Fig. A2
26” min
8-
7/8
”
A
B
CAUTION: At least two installers are required
due to the weight and size of the hood.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Cable Lock
Cable Lock
$FDEOHORFNLQJFRQQHFWRUQRWVXSSOLHGPLJKW
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
Installation – Mounting the Hood