Installation Guide

ManualsBrandsZephyr ManualsRange Hood AccessoriesZephyr Duct Cover Extension for use with the Surface Series Island Range Hoods

customer service

1.888.880.8368

Mounting the duct cover Pag. 4

Fixation des cheminees Pag. 6

Fijación de las chimeneas Pag. 8

Fissaggio dei camini Pag. 10

Duct Cover Extension

Z1C-00SL

For use with Surface Is. range hood

Summary of content (6 pages)

PAGE 1
customer service 1.888.880.8368 Duct Cover Extension Z1C-00SL For use with Surface Is. range hood Mounting the duct cover Pag. 4 Fixation des cheminees Pag. 6 Fijación de las chimeneas Pag. 8 Fissaggio dei camini Pag.
PAGE 2
www.zephyronline.com Min. 47-3/16" - Max.
PAGE 3
1. Before installing the duct cover extension kit, take out the duct cover ceiling bracket fom the range hood packaging and remove the bracket by unscrewing the (4) screws. 2. Remove the duct cover from the hood assembly, according to the following steps: A - Take out the lower mantle by removing the (7) screws. Fig. 1 B - Take out the spacer, by removing the (6) plus (4) metric screws and the bushes. Fig. 2 C - Take out the two additional bushes that secure the glass. Fig. 3 3.
PAGE 4
. Remove the (2) screws to unlock the top support frame from the bottom support frame. Fig.4. 5. Secure the top support frame to the duct cover ceiling bracket by using the (4) screws. Fig. 5 6. Position hole template on the ceiling paying attention that the arrow is positioned on the same side as the range hood controls. - Make 4 holes in the ceiling and drive in (3) screws without completely tightening them. Pay attention not to insert the screw into the hole marked with an X on the hole template. Fig.
PAGE 5
9. Insert the motor housing into the support frame assembly and secure it using (8) screws. Fig.10 10. Connect the equipment to the power supply. 11. Secure the correct size ducting for your installation (not supplied) to the collar on top of the housing. Fig.11 12. Extend upper duct cover to the ceiling and secure it to the duct cover ceiling bracket using the (4) screws previously removed when the assembly was taken out of the packaging. Fig. 12 13. Lift the hood assembly into the top duct cover.
PAGE 6
3FA0174