Installation guide

1. Measure from range top to hood bottom and mark line A.

(26” minimum from range top).

2. Plum and mark center line.

3. Mark mounting height line B. (10-1/4” from line A)

4. Mark mounting spread from C/L on line B. (9-7/16”)

5. Fasten (2) M6 x 1-1/4” screws into studs on line B. Do not

fasten screws all the way. note: wood blocking may need

to be added behind the drywall if no studs are present.

Wall anchors may also be used, check local codes

before using wall anchors.

6. Hang hood onto screws and hand tighten. (FIG. A #1) Use

the last M6 x 1-1/4” screw to further secure the hood to the

wall from inside the hood.

7. Center and attach duct cover bracket to wall below ceiling

or sofﬁ t using (2) M6 x 1” screws.

8. Remove tape securing electronics mounting bracket to

hood. Reposition electronics mounting bracket to hood and

secure by two pre-installed screws as shown in (FIG. B #1).

9. Install electrical.

10. *Install duct work and duct tape.

11. Power up hood and check for leaks around duct tape.

12. Place telescopic duct covers onto hood and extend inner

(top) duct cover upwards and secure to duct cover bracket

using (2) M4x3/8” screws.

*If using hood in recirculating mode you must secure air

diverter plate onto wall before installing duct work and duct

covers. Turn to page10 for more details.

C/L

10-1/4"

9-7/ 16"

C/L

26" min

Duct Cover Bracket

CAUTION: At least two installers are

required due to the weight and size of the

hood.

WARNING: Electrical wiring must be done by a qualified person(s) in

accordance with all applicable codes and standards. This range hood must be

properly grounded. Turn off electrical power at service entrance before wiring.

Installation – Mounting the Hood

Cable Lock

A cable locking connector (not supplied) might

be required by local codes. Check with local

requirements and codes, purchase and install

appropriate connector if necessary.

FIG. A

FIG. B