Installation guide

www.zephyronline.com

Installation – Mounting the Hood

Top Duct Covers

Top Support Frame

Bottom Duct Covers

Bottom Support Frame

Thin Trim Piece

Thick Trim Piece

 ,QVWDOOHOHFWULFDODQGGXFWZRUN$FDEOHORFNQRWVXSSOLHGPLJKWEHUHTXLUHGE\ORFDOFRGHV),*(

Seal duct work with aluminum duct tape.

6. Power up hood, verify all functions and check for leaks around duct tape.

 $VVHPEOH7RS'XFW&RYHUVZLWKORXYHUKROHVWRJHWKHURYHU7RS6XSSRUW)UDPHXVLQJ0[VFUHZV

RQHDFKVLGHRIWKHGXFWFRYHU),*)/DUJHUVFUHZKROHRSHQLQJVVKRXOGRYHUODSWKHVPDOOHUKROH

hopenings. Note: If using hood in ductless recirculating mode you must install the air diverter plate to the

Top Support Frame prior to assembling the duct covers. Turn to page 11 for more details.

 6HFXUH7RS'XFW&RYHUVWR7RS6XSSRUW)UDPHE\XVLQJ[´VFUHZV),*)

 $VVHPEOH%RWWRP'XFW&RYHUVWRJHWKHURYHUWRSGXFWFRYHUVXVLQJWKH¿QDO0[VFUHZVVFUHZV

RQHDFKVLGHRIWKHGXFWFRYHU),*)%RWWRP'XFW&RYHUVVKRXOGUHVWRQWRSRIWKH+RRG%RG\

,QVHUWWKH7KLQ7ULP3LHFHVLQWROHIWDQGULJKWVHDPVRI%RWWRP'XFW&RYHUVRQHDFKVLGH

),*)

,QVHUWWKH7KLFN7ULP3LHFHVLQWROHIWDQGULJKWVHDPVRI7RS'XFW&RYHUVRQHDFKVLGH

Note: Because less of the Top Duct Covers may be exposed, it may be necessary to measure

and cut the Thick Trim Pieces with a hack saw before installing them into the Top Duct Covers.

Measure and cut carefully.

FIG. F

Cable Lock

$ FDEOH ORFNLQJ FRQQHFWRU QRW

VXSSOLHG PLJKW EH UHTXLUHG

by local codes. Check with

local requirements and codes,

purchase and install appropriate

connector if necessary.

FIG. E

WARNING: Electrical wiring must be done by a qualified person(s) in

accordance with all applicable codes and standards. This range hood must be

properly

grounded. Turn off electrical power at service entrance before wiring.