French Door User Manual
Table Of Contents
- PRWB24C32BG_manual
- www.zephyronline.com
- PRWB24C32BG
- Presrv Dual Zone Wine and Beverage Cooler
- Table of Contents
- Page
- For your safety, read all instructions carefully before operating the appliance.
- DANGER: When using an electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons.
- Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
- Save These Instructions
- Disposal of Old Appliance
- Dispose of your appliance packaging properly.
- Refrigeration equipment must be properly disposed of in a way which protects the environment. This applies to your old appliance and to your new unit once it has reached the end of its service life.
- Before Using Your Appliance
- Installation of Your Appliance
- Attention
- Check that the voltage marked on the product corresponds with your supply voltage.
- Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard two-pin wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded...
- To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or dangling.
- Specifications
- Parts Identification & Dimensions
- Installation Instructions
- Carbon Filter
- A built-in carbon filter protects your wine and beverages by acting as a natural barrier against harmful odors. The carbon filter should be replaced every 3-6 months depending on the unit’s exposure level to odor. If the unit is placed in a kitchen, r...
- Remove the carbon filter by turning counterclockwise to unlock from rear panel.
- Carbon Filter Replacement Part #: Z0F-C004
- Installation Clearance Requirements
- When installing the wine and beverage cooler under a counter, follow the recommended spacing dimensions shown.
- Installation Instructions
- Installation Clearance Requirements cont.
- When installing the wine and beverage cooler under a counter, follow the recommended spacing dimensions shown.
- Installation Instructions
- Installation Instructions
- In this mode, the compressor and fans never turn on but all other functions remain enabled.
- Defrosting
- Power Failure
- Moving Your Wine and Beverage Cooler
- Energy Saving Tips
- Troubleshooting
- warranty_5yr_2yr_1yr_refrigeration
- PRWB24C32BG_manual_fr
- www.zephyronline.com
- PRWB24C32BG
- Refroidisseur de vin et de boissons à deux zones Presrv
- Tables des matières
- Page
- Pour votre sécurité, lisez toutes les instructions avec soin avant de faire fonctionner l’appareil.
- DANGER : Lors de l’utilisation d’un électroménager électrique, vous devriez toujours prendre des précautions de base pour réduire les risques d’incendie, de décharge électrique et de lésion corporelle.
- Placez l’appareil à un endroit où il est à l’abri de la lumière directe du soleil et de sources de chaleur (cuisinière, chaufferette, radiateur, etc.).
- Conservez les présentes instructions
- Mettez l’emballage de votre appareil au rebut de façon adéquate.
- Le matériel de réfrigération doit être mis au rebut convenablement et d’une manière respectueuse de l’environnement. Cela s’applique à vos vieux électroménagers et à votre nouvel appareil à la fin de sa vie utile.
- Avant d’utiliser votre appareil
- Installation de votre appareil
- Attention
- Assurez-vous que la tension indiquée sur le produit correspond à la tension d’alimentation.
- Faites vérifier la prise murale et le circuit par un électricien qualifié pour vous assurer de la mise à la terre adéquate de l’appareil. Lorsque la prise murale ne compte que deux bornes, il est de votre responsabilité et de votre obligation de la fa...
- Pour prévenir toute blessure accidentelle, le câble doit être fixé à l’arrière de l’appareil, ne pas être exposé et ne pas pendre librement.
- Spécifications
- Identification des pièces et dimensions
- Instructions d’installation
- Filtre à charbon
- Un filtre à charbon intégré protège vos vins et boissons en agissant comme une barrière naturelle contre les mauvaises odeurs. Vous devriez remplacer le filtre à charbon tous les trois à six mois, selon le niveau d’exposition de votre appareil aux mau...
- Pour retirer le filtre à charbon du panneau arrière, faites-le tourner dans le sens antihoraire.
- No de pièce du filtre à charbon de remplacement : Z0F-C004.
- Espace libre requis pour l’installation
- Lors de l’installation du refroidisseur à vin et à boissons sous un comptoir, veuillez respecter les espaces libres recommandés ci-dessous.
- Instructions d’installation
- Espace libre requis pour l’installation cont.
- Lors de l’installation du refroidisseur à vin et à boissons sous un comptoir, veuillez respecter les espaces libres recommandés ci-dessous.
- Instructions d’installation
- Avec ce mode, le compresseur et les ventilateurs ne s’allument jamais, mais toutes les autres fonctions demeurent actives.
- Dégivrage
- Panne d’électricité
- Déplacement du refroidisseur à vin et à boissons
- Conseils d’économie d’énergie
- Dépannage
- warranty_5yr_2yr_1yr_refrigeration_FR
12
Installation Instructions
Carbon Filter
A built-in carbon filter protects your wine and beverages by acting as a natural barrier
against harmful odors. The carbon filter should be replaced every 3-6 months
depending on the unit’s exposure level to odor. If the unit is placed in a kitchen, regular
replacement every three months is ideal.
Remove the carbon filter by turning counterclockwise to unlock from rear panel.
Carbon Filter Replacement Part #: Z0F-C004
Installation Clearance Requirements
When installing the wine and beverage cooler under a counter, follow the recommended
spacing dimensions shown.
To ensure proper service access and ventilation, allow at least 1” of clearance at
the back as shown in the diagram.
The installation should allow the unit to be pulled forward for servicing, if
necessary.
The power cable is located on the back right of the unit and has a length of 72” to
accommodate multiple outlet locations.
An installation next to a wall will require a minimum 2-1/4” door clearance to
accommodate the handle.