User Manual

18
Electrical Wiring Installation
Plug downdraft’s power cord into outlet.
Note: Make sure that power cord is routed away from the heat gen-
erated by the cooktop.
Plug electrical panel cover into lower receptacle as shown.
Connect blower wires to wires in wiring box. Replace wiring box cover.
Mount a standard wiring box, with 3-pronged receptacle, within
reach of downdraft’s power cord. Run appropriate power cable and
connect it to receptacle.
CAUTION
All electrical wiring should be done by a qualified
person(s) in accordance with all applicable codes
and standards.
• If using a remote blower (purchase separately), the
system draws 6.0 Amps (max.) and requires a 120 VAC,
60 Hz circuit.
• The unit has a 30 in. long power cord with a 3-pronged plug
attached to the electrical panel. Plan to provide a grounded
outlet in a location which will allow the unit’s power cord to
reach.
• Install electrical box according to local codes.
Exterior or In-Line Blower only
18b
22b
20a21b
Remove wiring box cover and route blower wire into wiring box.
From Exterior or
In-Line Blower
From Exterior or
In-Line Blower
19b
I
White (Common)
Gray (Med.) Blue (Med.)
Black (High)
Greed (Ground)
Lift
Downdraft
Remote
Blower
White (Common)
Blue (Low)
Red (Low)
Green (Ground)
Orange (High)
Black (High)
20b