User Manual

16
CAUTION
BEFORE CUTTING HOLE IN CABINET FOR
DUCTWORK, check for interference with floor
joists, wall studs, electrical wiring, or plumbing.
• Refer to Ductwork Configurations in the Planning section of this
document.
• Cut hole in cabinet as well as holes in wall or floor as necessary.
• Mount the roof or wall cap and work back towards the cabinet,
attaching all ductwork, elbows and transitions as previously
planned. Tape all ductwork connections to make them secure and
air tight.
• Connect ductwork (and transition, if required) to downdraft.
Place retaining washer on left trim cap (C). Insert hinge pin into slot of the
flip door. Position left trim cap and flip door. Align trim caps and complete
assembly by tightening trim cap nut.
Note: Make sure trim sits flat on countertop surface, is flush with top door,
and has 1/16” GAP between trim and top door.
End cap trim peices are available, extending each trim by 1”. See Optional
Accessory page for more information.
Installation
Position right trim cap (D). Place retaining washer on right trim cap. Insert
hinge pin into slot of the flip door. Secure right trim cap by trim cap nut.
Note: Make sure trim: sits flat on countertop surface, is flush with top door,
has 1/16” GAP between trim and top door, and wiring is not pinched.
Installing Finish Trim (continued)
Installing Ductwork
Door Trim
1/16" Gap1/16" Gap
Washer
TOP VIEW
Flush
3
2
4
16
1
D
D
Retaining
Washer
Retaining
Washer
D
TOP VIEW
Flush
2
3
17
1
C
Retaining
Washer
Retaining
Washer
C
C
DoorTrim
1/16" Gap1/16" Gap
Washer
2
Installing Finish Trim
CAUTION
Only connect or disconnect UP BUTTON CABLE
with main power off for at least 60 seconds.
Insert wiring harness with wire from right upper button (D) into opening
in side of downdraft (B). Insert upper button (D) wiring harness into
receptacle at lower right side of downdraft (B).
15
1
B
D
2