User Manual

15
Installation
Level housing.
Note: Steps 11-15, right cabinet not shown for clarity.
Attach support legs (E) to bottom of cabinet with two screws (AA) per
leg. Tighten hex screws. Note: If cabinet bottom is removed, use blocks
as spacers between floor and support legs.
Extend upper support brackets (A) and attached to sides of cabinet with
two screws (BB) per bracket.
Remove cook top/appliance and cut opening.
Cutting Counter Top Opening (continued)
Install Housing into Cabinet
Install Housing into Cabinet
(continued)
9
Set housing into cabinet.
10
11
1
1
12
2
E
AA
1
1
13
2
A
BB
Loosen four screws attaching blower support legs to DBI-600A blower.
Extend legs and secure to bottom of cabinet with one screw through
each bracket. Re-tighten four blower screws.
1
2
2
14
DBI-600A Blower Only
4
3
1