Use and Care Manual

17
Plug downdraft’s power cord into outlet.
Note: Make sure that power cord is routed away from the heat
generated by the cooktop.
Plug electrical panel cable into lower receptacle on side of downdraft.
The DBI-600A blower is capable of maximum CFM of 600 CFM or 400 CFM.
Connect blower wires to wire in electrical panal as needed for your CFM
requirements.
Remove electrical panel (I) cover and route blower wire into wiring box.
Mount a standard wiring box, with 3-pronged receptacle, within reach
of downdraft’s power cord. (Run appropriate power cable and connect it
to receptacle.)
Electrical Wiring Installation
DBI-600A Blower only
CAUTION
All electrical wiring should be done by a qualified
person(s) in accordance with all applicable codes
and standards.
• This downdraft blower using the DBI-600A Blower (purchase
separately) draws 3.0 Amps and requires a
120 VAC, 60 Hz circuit.
• The unit has a 30 in. long power cord with a 3-pronged plug
attached to the electrical panel. Plan to provide a grounded
outlet in a location which will allow the unit’s power cord to
reach.
• Install electrical box according to local codes.
18a
19a
I
White (common)
Grey (med.) Red (med.)
Black (high)
Green (ground)
Lift
Downdraft
DBI-600A
Blower
White (common)
Blue (low)
Blue (low)
Green (ground)
Orange (high)
Black (high)
Orange (Cap Off)
20a
22a
21a21a
White (common)
Grey (med.) Red (med.)
Black (high)
Green (ground)
Lift
Downdraft
DBI-600A
Blower
White (common)
Blue (low)
Blue (low)
Green (ground)
Orange (high)
Orange (high)
Black (Cap Off)
600 CFM WIRING SET UP
400 CFM WIRING SET UP