User Manual

18
Okeanito Use, Care, and Installation Guide
OKEANITO
WALL
DESIGNER
Features & Controls
Touch Controls
Bae Filter Clean Reminder
A set of bae filters are fitted by the factory, these bae filters are intended to filter
out residue from cooking. The filters need not be replaced on a regular basis but are
required to be kept clean. The Bae Filter Clean reminder function in the microproces-
sor will automatically indicate by a flashing when the bae filters need to be
cleaned after every 60 hours of use. Filters can be cleaned by hand with non-abrasive
soap or in a dishwasher. Heavily soiled filters should also be soaked in grease cutting
detergent prior to cleaning.
Bae Filter Clean Indicator
When flashes on the display, the bae
filters needo be cleaned. This will occur
after every 60 hours of use.
Reset the filter clean reminder timer after
filters are cleaned and re-installed. With
hood o, press and hold for approxi-
mately 5 seconds until on display
disappears . The filter clean reminder
function is now reset and a new 60 hours
elapse cycle is initiated.
Clean Filters
display < F > flashes
hold 5 sec. display from < F > to < >
To Reset
hold 3 sec. display fr
om < A > to < >
To Disable
hold 3 sec.
To Enable
display < A > flashes
Clean Air Indicator
While Clean Air is activ
e, the display will
alternate betw
een , , , .
Af
ter 10 minutes of Clean Air operation, the
blo
wer will power o and the 4 hour timer
will r
eset.
If the blo
wer speed is changed while the
Clean Air Function is in use
, the cycle will be
in
terrupted and the timer will reset after.
Clean Air Function
Clean Air is a featur
e that turns on the blower on low speed every 4 hours for 10 minutes
to r
emove stagnant air in the kitchen. The Clean Air function is disabled by default and
mus
t be enabled by the user.
and
and
F
F
F
F
F
F
A
A
A
A
A
A
1
1
1
1
A
A
F
F
F
F