User Manual

14
Okeanito Use, Care, and Installation Guide
OKEANITO
WALL
DESIGNER
Installation Instructions
Remote Blower Preparation
2. Install remote blower 8” round
collar. Attach by (4) M4*8 screws.
1. Remove internal blower flange
from motor housing by (6) screws.
3. Install threaded cable lock and
remote blower wiring harness
through the remote blower wiring
knockout. Attach by (4) M4*8
screws.
5. Connect 6 pin male connector
from remote blower wiring to 6
pin female connector on control
board box.
4. Secure ground wire from remote
blower wiring to ground wire rivet
nut.
NOTE: For instructions on mounting
the remote blower, please refer to
the CBE-1000 or PBN-1000A remote
blower manual included in the remote
blower packaging or on our website at
www.zephyronline.com