Hood User Manual

10
www.zephyronline.com
INTERNAL BLOWER PREPARATION
1. Position internal blower inside hood body so
LQWHUQDOEORZHUFROODUSURWXUGHVWKRXJK´URXQG
ÀDQJHRSHQLQJ
6HFXUHLQWHUQDOEORZHUWRLQWHUQDOEORZHUÀDQJH
E\0VFUHZVIURPLQWHUQDOEORZHU
hardware.
3. Position capacitor box inside hood body and
VHFXUHE\0VFUHZVIURPLQWHUQDOEORZHU
hardware.
4. Secure ground wire from capacitor box to
ground wire rivet nut next to capacitor box.
5. Connect 9 pin molex connector from internal
motor to 9 pin molex connector from capacitor
box cable. Secure cable to hood interior with zip
tie and zip tie holder.
6. Connect 6 pin molex connector from control
board box to 6 pin molex connector from
capacitor box cable. Secure cable to hood
interior with zip tie and zip tie holder.
Installation – Internal Blower