Hood Manual

11
Installation – Remote Blower Preparation
3. Install threaded cable lock and remote blower
wiring harness through the remote blower
wiring knockout. Attach by (4) M4*8 screws.
5. Connect 6 pin male connector from remote
blower wiring to 6 pin female connector on
control board box.
REMOTE BLOWER PREPARATION
1. Remove internal blower fl ange plate.
2. Install remote blower 8” round collar. Attach by
(4) M4*8 screws.
NOTE: For instructions on mounting the remote
blower please refer to the CBE-1000 or PBN-
1000A remote blower manual included in the
remote blower packaging or on our website at
www.zephyronline.com
4. Secure ground wire from remote blower wiring
to ground wire rivet nut.