Arc User Manual

- 7 -
2.1 SYNCHRONISATION:
To synchronise the remote control with the range hood for
the  rst time, proceed as follows:
1. With range hood o , press and hold the “lights” button on
the range hood until the light indicator begins to  ash.
Fig.1
2. Rotate the upper part of the remote control until the “lights”
indicator light on the range hood switches o . Fig. 2
The range hood may now be activated using the remote
control. If you experience any problems, repeat the
procedure.
2.2 OPERATION:
- BLOWER SPEED:
The blower speed may be adjusted by rotating the upper
part of the remote control and aligning the marker with the
desired speed. Fig. 2
0= O
1= Low
2= Medium
3= High
- LIGHTS:
The lights may be switched on by pressing the remote
control. Fig. 3
The brightness may be progressively reduced by pressing it
a second or third time.
The fourth time the remote control is pressed, the lights will
be switched o .
2.3 GENERAL INFORMATION:
- The remote control has a range of approximately 15-20
feet.
- The remote control is equipped with a magnetic base and
may therefore be attached to ferrous surfaces.
- BATTERY REPLACEMENT:
The battery will last for approximately 12-15 months,
depending on usage.
1. Remove the rubber cover as shown in Fig. 4
2. Remove the battery by pressing the side of it. Fig. 5
3. Replace the battery with a 3 volt type 5004LC / CR 2032
2. Remote Control