Hood User Manual

- 30 -
FIG.40
FIG.41
MESH FILTERS
NOTE: prior to use, remove protective fi lm
from the fi lter frame.
NON-DUCTED HOODS ONLY
1. To remove the CHARCOAL fi lter, grip
and push fi lter tab toward rear of hood.
Pull the fi lter down to disengage the rear
fi lter tabs.
2. To install the CHARCOAL fi lter, align
fi lter in rectangular opening. Push fi lter
against springs in rear of hood and press
into place (Fig.40). Make sure the fi lter
is securely engaged after assembly.
3. Install MESH fi lter after charcoal fi lter is
installed.
4. The charcoal fi lter replacement model
is Z0F-01AC.
DUCTED AND NON-DUCTED HOODS
1. To remove the MESH fi lter, pull down
on latch tab to disengage the fi lter from
the hood. Tilt the fi lter downward and
remove.
2. To install the MESH fi lter, align rear fi lter
tabs with slots in the hood. Pull latch tab
down. Push fi lter into place and release
tab (Fig.41). Make sure the filter is
securely engaged after installation.
Model ALU-E43
Model ALU-E63
Model ALU-E43
Model ALU-E63