Use and Care Manual

21
Lux Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Features & Controls
Laminated Touch Controls
Blower On/O
1
Fan; 3 speed levels
2
Lights; Low/Medium/High/O
3
Auto-O Indicator
4
Clean Air Active Indicator
5
Bluetooth® Indicator
8
Wi-Fi Indicator
9
Replace Charcoal Filter Indicator
6
Clean Grease Filter Indicator
7
Fan speed indicator
2
1. Blower On/O
► By pressing On/O, the blower is switched on and o. When switched on, the blower starts up on
speed level 1.
2. Fan Speed Selection
► Pressing Fan cycles through the fan speeds from 1 to 2, 3 and o. The current speed level will be
indicated by the lit graphics.
3. Lights; O/Low/Medium/High
► Pressing Light cycles through the light levels from 1 to 2, 3, and o. The current light level will be
indicated by the lit graphics.
4. Auto Delay O
► This feature is used for programmed shutdown of the blower 10 minutes after the function is
activated. The fan speed level will change to 1, and the Auto-O graphic will illuminate. Press and
hold On/O for 3 seconds while the fan and/or lights are on to enable auto delay o. The blower
will completely shut down after 10 minutes. The Zephyr Connect app provides the options for
either 5 or 10 minutes.
5. Clean Air Active
► When activated, it turns the hood on fan speed level 1 for 10 minutes every 4 hours and will be
shown by the indicator lighting up and fan speed level 1 slowly pulsing. To enable Clean Air Active,
press and hold Light and Fan for 3 seconds while the hood is o.