Use and Care Manual
Table Of Contents
18
Monsoon Mini II Use, Care, and Installation Guide
MONSOON MINI II
INSERT
CORE
Features & Controls
Electronic Touch Controls
1
Power / Delay O Button
- Button will turn power on and o for entire hood (fan and lights.)
- Hood will remember the last speed and light level it was last turned o at.
(Example: Press button to turn o hood when on fan speed 3 and high lights.
Press button again and the hood will turn back on at speed 3 and high lights.)
Delay O
- With the fan on, press and hold the button for two seconds. The fan will change to
speed 1, the button will blink on and o indicating the 5 minute delay o timer has
started.
- Pressing button while delay o function is enabled will turn the hood o and cancel
the delay o function.
ACT Verification
- Airflow Control Technology (ACT) allows the installer to set the maximum fan CFM to align
with local codes and regulations.
- To verify the maximum fan CFM:
- With hood o, hold the button for five seconds. If all three fan speed indicators
illuminate = default maximum CFM. If speed level 1 and 2 indicators illuminate = 390
maximum CFM. If only speed level 1 indicator illuminates = 290 maximum CFM.
2
Lights Button
- Lights are two levels, low and high.
- From o, press one time for low. Press again for high. Press again to power lights o.
3
Speed Level Indicators
- Fan is three speed levels. 1 for low speed, 2 for medium speed, and 3 for high speed.
/
1 2 3
1
Power / Delay O
2
Lights O/Low/High
3 Speed Indicators
/
/
/
/
/
/
/
/