Use and Care Manual / Installation Instructions

14
www.zephyronline.com
1
2
1
Installation – Horizontal Ducting Preparation
12. Position blower inside liner body as shown by:
1)5HVWWKHERWWRPKRUL]RQWDOGXFWLQJEUDFNHW
on the two support clips located on the interior
EDFNZDOORIWKHOLQHU2) Pivot top horizontal
GXFWLQJEUDFNHWWRPHHWFDSWLYHQXWVRQLQWHULRU
EDFNZDOO
13. Secure blower to captive nuts on interior
EDFNZDOORIOLQHUZLWK´[´VFUHZV
VFUHZVIRUHDFKEUDFNHW6HDODQ\JDSV
DURXQGWKHNQRFNRXWSODWHE\XVLQJFHUWL¿HG
aluminum duct tape. Plug in blower molex
plug.
Horizontal ducting preparation is now
complete. Refer to Page 10, Step 5 to
complete installation.
10. (Rectangular Ducting) From inside the liner,
push 3-1/4” x 10” rectangular adaptor through
WKHEDFNNQRFNRXWDQGVHFXUHWRLQWHULRUEDFN
ZDOORIOLQHUZLWK0[PPVFUHZV
10. (Round Ducting) From inside the liner, push
´URXQGDGDSWRUWKURXJKWKHEDFNNQRFNRXW
DQGVHFXUHWRLQWHULRUEDFNZDOORIOLQHUZLWK
M4 x 6mm screws.
11. 6HFXUHKRUL]RQWDOGXFWLQJEORZHUEUDFNHWV
WREORZHUDVVKRZQDERYHE\XVLQJWKH
3/16” x 3/8” screws previously removed from
3DJH6WHSVFUHZVIRUHDFKEUDFNHW
AK9228AS and AK9234AS Models Only