Owner Manual

16
Monsoon Mini Use, Care, and Installation Guide
MONSOON MINI
INSERT
CORE
Installation Instructions
Ducting Preparation
If using hood in recirculating mode, skip these steps and turn to the next page.
Vertical Ducting
(7" Round)
Vertical Ducting
(3-1/4"x10"
Rectangular)
1. Using a flat-head screwdriver,
remove both the rectangular and
round knock-out plates located on
top of hood.
1. Using a flat-head screwdriver,
remove only the rectangular section
of the knock-out plate located on
top of hood.
1. Using a flat-head screwdriver,
remove the rectangular knock-out
plate located on back of hood.
2. Secure 3-1/4" x 10" rectangular
collar to top of hood using (6) M4 x
6 screws.
2. Secure 3-1/4" x 10" rectangular
collar to back of hood using (6) M4
x 6 screws.
2. Secure 7" round collar to top of
hood using (6) M4 x 6 screws.
Horizontal Ducting
(3-1/4" x 10"
Rectangular)