Hood User Manual
16
Tornado Glo Use, Care, and Installation Guide
TORNADO GLO
INSERT
CORE
Features & Controls
1. Power On/O
By pressing the last retained blower fan speed and lights are
switched on and o.
ACT Verification
- Airflow Control Technology (ACT) allows the installer to set the
maximum blower CFM to align with local codes and regulations.
- To verify the maximum blower CFM:
- With hood o, hold the button for 3-4 seconds. If number
6 displays = default max. CFM, if number 3 displays = max. 390 CFM,
and if number 2 displays = max. 290 CFM.
2. Speed Selection
- Press to decrease fan speed. 6, 5, 4, 3, 2, 1.
- If fan is on Speed 1 and is pressed, the fan will power o.
- Press to increase fan speed. Fan On, 1, 2, 3, 4, 5, 6.
- If hood is o and is pressed, the fan will turn on speed 1.
ACT Enabled Speed Selections
- When ACT is enabled, the number of blower speeds will be
reduced as follows:
- 390 CFM = Maximum 3 speeds
- 290 CFM = Maximum 2 speeds
3. Delay O
This feature is used for programmed shut down of blower 5 min-
utes after the function is activated. Press once, a dot flashes in
the lower right side of display indicating the function is on. The
blower will completely shut down after 5 minutes.
4. Lights Low/High/O
Switch lights on to low by pressing once, press a second time for
high and again to shut o lights.
5. Display Window
The display window indicates speed levels and features such as
bae filter clean reminder, delay o and clean air indicator.
Lights Low/High/O
5 Min Delay O
Display (speed level, delay o, filter clean)
Adjust 6 Speed Levels
Power On/O
1
2
3
4
5
Touch Controls