Use and Care Manual

15
FCC Caution:Toassurecontinuedcompliance,anychangesormodicationsnotexpresslyapprovedbytheparty
responsible for compliance could void the user’s authority to operate this equipment. (Example - use only shielded interface
cables when connecting to computer or peripheral device. This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions. (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
REMOTE CONTROL MAINTENANCE:
Clean the remote control using non abrasive detergents
Follow instructions below for replacing battery.
Usingasmallatheadscrewdriver,raisethecoverofthebatterydoor(A)
in order to access the battery compartment.
Remove the battery and replace with Type A23 12V.
Negative end of battery should face the spring inside the remote.
Replace battery door and recycle old battery.
Blower On / Speed Selection
Press to power on blower and cycle through all six blower speeds.
Blower On / Power Off
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
Lights On / Dim / Off
Switch lights On by pressing once, again to dim and again to switch Off.
Blower On/
Speed Selection
1
1
2
3
4
Blower On/
Power Off
2
5 Min Delay Off
3
Lights On/Dim/Off
4
By pressing , the blower and lights will enter Delay Off mode. A dot will
appear in the lower right corner of the hood display indicating the function
is on. The blower will change to speed 1 and shut down after 5 minutes.
A
-
+
REMOTE CONTROL FEATURES:
The RF remote control is equipped with a magnet for easy storage. The remote may be placed on any magnetic surface such
as a refrigerator or the Zephyr remote holder. Maximum remote control communication distance from power pack is 15 feet.
This remote control may operate in humid environments, but not when placed on a wet surface.
SYNCHRONIZATION: To create a unique link between your range hood and remote control please follow the below steps:
1.Withrangehoodo󰀨,pressandholdthe“lights”buttonontherangehooduntiltheletter“F”showsonthedisplayscreen. 
2.Pressthe“lights”buttonontheremote,thelightsonthehoodwillturnon.Thesynchronizationiscomplete.
Features & Controls – RF Remote Control