Installation guide





1. Position blower plate over bracket on inside
back of hood and pivot up. Secure plate to hood
with (2) 10x3/16” screws. (blower pictured is a
PBI-1100A)
2. Connect 6 pin male connector from blower
wiring to 6 pin female connector in the power
pack. (plug is located inside the power pack
protruding from the white control board box).
3. – Connect 6” round duct work to
blower collar.
– Place 8” round adapter on top of
power pack and secure with (4) M4x8 screws.
Connect 8” round duct work to 8” round adapter.
