Use And Care Manual / Installation Guide

10
www.zephyronline.com
C/L
C/L
A
B
16 7/8”
min
26”
4”
wood board
FIG. 1
16 7/8”
16 1/8”
13 5/8”
1 11/16”
3 5/16”
21 1/4”
27 3/8” (36“ & 42”), 35 1/4” (48” & 54”)
5 5/16”
FIG. 2
Installation – Mounting the Range Hood
6HOHFWSUHIHUUHGGXFWLQJDSSOLFDWLRQYHUWLFDORUKRUL]RQWDODQG
prepare hood. Refer to page 11 for single blower horizontal
ducting, page 13 for dual blower vertical ducting or page 14 for
dual blower horizontal ducting.
 3OXPDQGPDUNFHQWHUOLQHRQZDOO
 &KRRVHGHVLUHGKHLJKWDERYHFRRNLQJVXUIDFH´PLQ/HYHO
DQGPDUNKRRGERWWRPOLQH$),*
 /HYHODQGPDUNWRSRIZRRGERDUGOLQH%),*´IURP
line A.
 0DUNFHQWHUOLQHRIZRRGERDUG&HQWHUDQGDOLJQWRSRIERDUGZLWK
OLQH%6HFXUHZRRGERDUGWRVWXGVXVLQJ0ZRRGVFUHZV
Wood Board Dimensions:['[+
AK7500BS - 27” x 1/2” x 4”
AK7536BS - 33” x 1/2” x 4”
AK7542BS - 39” x 1/2” x 4”
AK7548BS - 45” x 1/2” x 4”
AK7554BS - 51” x 1/2” x 4”
6. Prepare duct pipe and duct cut outs in upper cabinet if needed or
ZDOO,IKRUL]RQWDOO\GXFWLQJKRRG5HIHUWRKRRGVSHFL¿FDWLRQVRQ
page 8 for dimensions.
7. Prepare electrical wiring and electrical cut outs in upper cabinet if
QHHGHGRUZDOOLIKRUL]RQWDOHOHFWULFDOKRRNXSLVUHTXLUHG5HIHUWR
KRRGVSHFL¿FDWLRQVRQSDJHIRUGLPHQVLRQV
 0RXQWKRRGRQWRZRRGERDUGDQGVHFXUHXVLQJ0ZRRG
screws.
9. Further secure hood onto wall through lower body screw holes by
0ZRRGVFUHZV6HHGLPHQVLRQVLQ),*
10. Install electrical.
,QVWDOOGXFWZRUNDQGVHDOZLWKFHUWL¿HGDOXPLQXPGXFWWDSH
3RZHUXSKRRGDQGFKHFNIRUOHDNVDURXQGGXFWWDSH
,QVWDOOEDႉH¿OWHUV
CAUTION: At least two installers are required
due to the weight and size of the hood.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!