Use and Care Manual

This range hood is equipped standard with a 8” round vertical duct option. To convert from 8” round vertical to 8”

round horizontal ducting or 3-1/4” x 10” rectangular horizontal ducting please following the instructions below.

NOTE: Horizontal ducting is only available for the single internal blower.

NOTE: If horizontally ducting via 3 1/4” x 10” rectangular ducting, the maximum airﬂ ow of 650 CFM will

be reduced to 550 CFM. Other CFM levels will not be affected.

VERTICAL TO HORIZONTAL DUCTING CONVERSION

1. Disconnect blower plug.

2. Remove (4) screws at top of hood body attaching

blower to blower plate. Remove blower from

interior of hood body.

3. Remove (4) screws from interior of hood body

attaching blower plate to hood body. Remove

blower plate.

4. Knock out rear plates A & B for 8” round

rear ducting or plate B only for 3 1/4” x 10”

rectangular rear ducting.

Installation – Horizontal Conversion