Installation Guide

This range hood is equipped standard with a 8” round vertical duct option. To convert from 8” round vertical to 8”

round horizontal ducting or 3-1/4” x 10” rectangular horizontal ducting please following the instructions below.

NOTE: Horizontal ducting is only available for the single internal blower.

127(,IKRUL]RQWDOO\GXFWLQJYLD´[´UHFWDQJXODUGXFWLQJWKHPD[LPXPDLUÀRZRI&)0ZLOO

be reduced to 550 CFM. Other CFM levels will not be affected.

VERTICAL TO HORIZONTAL DUCTING CONVERSION

1. Disconnect blower plug.

5HPRYHVFUHZVDWWRSRIKRRGERG\DWWDFKLQJ

blower to blower plate. Remove blower from

interior of hood body.

 5HPRYHVFUHZVIURPLQWHULRURIKRRGERG\

attaching blower plate to hood body. Remove

blower plate.

4. Knock out rear plates A & B for 8” round

rear ducting or plate B only for 3 1/4” x 10”

rectangular rear ducting.

Installation – Horizontal Conversion